Made in the middle of the bed, getting the middle of the bed height correct In my experience, the bed may not be exactly flat, and the center of theīed may be higher or lower than the corners. Lower all of the 4 corner wheels! Repeat this process a couple of times. When adjusting the middle of the bed, you must raise or (makes it looser.) Repeat this several times for each corner and the The bed (makes it 'tighter') and turning counterclocwise lowers the bed Make the nozzle just scrape the piece of paper. To adjust the bed level at each corner, you will move the head to eachĬorner and turn one of the 4 large black knobs on the bottom of the bed to Raise the Z axis off of the bed before moving it on the X and Y axes!

Manually move the nozzle to all 4 corners and the center of the print bed,Īdjusting the bed height so that the nozzle just scrapes the piece of paperĪnd the paper can slide with just a tiny bit of resistance. In short, you will first place the piece of paper on the print bed and then

Move Axis (and then move the X, Y, and Z axes a bunch of times.

Menu items you will need are under Prepare and are: Your print bed is leveled and at the right initial height from the nozzle.įor this, you will need a typical sheet of typing paper.įor your first attempts, I recommend that you manually level the bed by The most important thing you can do to ensure a good print is making sure Loose and your prints will be slightly misshapen (too narrow) on the X The belt tightening and loosening as it moves left and right, it's too That you have to attach, but it should be about as tight as you can pull

How tight should your belts be? Very tight! There is only one belt.

To attach the belt, you bend the ends at 90 degree angles and put the.

The belt's teeth should face the teeth on the sprockets, that is,.

There is one belt you have to attach for the X-axis.

There was one that was sort of easy to miss in the

Make sure all of the limit switch cables and stepper motorĬables are attached.

Think about how these will lay before completelyĪssembling your printer! We didn't, and had to partially disassemble a

There are several pre-attached cables.

Make sure you have switched the voltage on the power supply from 230 to.

What each motor moves as you put it together! Here are a few things to We assembled the printer, having no idea what we wereĭoing, in about 90 minutes working slowly and carefully. Use the printed directions but refer to the video Note that the order of assembly in the video does not exactly match There is an assembly video on the USB drive that comes with the printer Inserted into the slot on the front of your printer. Your models! The MicroSD card pulls out of the USB drive carrier and is The USB drive contains a MicroSD card which is the way you will also print

I may have also printed out some of these Printer! Plug this into your computer and you will find assembly videos, The printer's documentation is on the little USB drive that comes with your When you first open the printer box, you may be wondering 'where is myĭocumentation?' There is a printed fold-out assembly guide, but not much

Glass Bed or Magnetic Mat? Where is my Documentation?.The latest version of this document is always found It is mostly specific to the 3-D printer that we all have, the This is a quick-start guide for my friends getting started with 3-D

Creality slicer download